Cafe racer seat blank hump seat, black Top-Angebot

The removable upholstery frame and the cusps are deep-drawn thermoplastic.
Therefore not so stiff as for example Fiberglass. This man gives himself
experience shows that discussions with the auditor about strength and fracture behaviour.

We recommend a mounting on a stable base.

The upholstery frame can be very easily with only two screws of the saddle
separated and reassemble.

Fits with a little craftsmanship sure on many different machines.

Dimensions:

-Length: 600 mm
-Front width: 185 mm (measured on the inside)
-Length of the seat surface: approx. 330 mm
-maximum width rear: 235 mm (measured on the inside)

Other dimensions of this seat on request.

The bench is supplied on request with an opinion of the material.

This as a single bench seat is entered according to TÜV
must be because the seat with their approx. 33 cm length to
is short for the two-man operation.

For the creation of a seat base you will find the following components with us in the shop

IMPORTANT NOTE

Please take note that we retorted, not suitable goods only
full refund without damage .
Therefore make sure the car seat when you place on the frame,
not to damage (E.g. by sharp parts of the frame or by sitting on
without proper installation). Thank you very much!