Letzte Chance Mikuni TM34 Flatslide Carburator for Yamaha XS 650

Mikuni TM34 Flat Slide Carburetor for your Yamaha XS 650

Do you want to give your XS 650 a sportier character while eliminating the weaknesses of the old carburetor design? Then this Mikuni flat slide carburetor is just the right choice for you!

Compared to the original round slide carburetor, the TM34 delivers quicker throttle response, stronger pull, and – depending on your setup – up to 5 extra horsepower. Perfectly tuned by Mikuni specialists, featuring a precisely adjusted accelerator pump and cold start device – just install and ride!

Your benefits:

•Faster throttle response & more power across the entire rev range

•Perfectly tuned for the Yamaha XS 650 (also works with 750ccm kit)

•Ideal replacement for discontinued original carburetors

This model is the best choice for stock engines used on the street. If you’re running a BigBore engine (over 750ccm) or plan to use it exclusively for racing, check out the TM36 version in our shop.

Please note:

This carburetor is designed for racing use and does not have TÜV approval – however, registration may be possible after consultation with your inspector.

The intake manifolds of the Yamaha XS 650, model 3L1, must be used.

Technical details:

•Choke: left, pull knob

•Idle adjustment: left

•Fuel inlet: left

Dimensions:

•Outer diameter front: 42 mm

•Outer diameter rear: 55 mm

•Overall length: 100 mm

•Venturi center top: 82 mm / bottom: 78 mm

•Carburetor spacing: 120 mm

Note: Every Yamaha runs a little differently, so fine-tuning may be required. Jets are available from us – please use only original Mikuni jet kits!

Since this is a custom-made product, it is excluded from returns/exchanges (see terms & conditions). Additionally, delivery times may be longer due to special ordering from the manufacturer – please refer to the information above the price.

Made in Japan – specially tuned for your Yamaha XS 650.